Nail lamp dual UV/LED 1s for hybrid varnishes, gels and acrylic gels No Name 48W white
zoom_out_map
chevron_left chevron_right
New

Nail lamp dual UV/LED 1s for hybrid varnishes, gels and acrylic gels No Name 48W white

Nail lamp dual UV/LED 1s for hybrid varnishes, gels and acrylic gels No Name 48W white

                                        Without warranty !!!

Hybrid manicure and pedicure lamp UV/LED 1s dedicated to curing hybrid varnishes, gels and acrylic gels.

The combination of perfect appearance with extraordinary functionality are the two main features of the 1s lamp. The lamp has 4 operating modes for 30, 60 and 90 seconds and an additional Low Heat Mode mode enabling gradual heating of the lamp, helpful in curing building gels. Thanks to its lightweight and compact design, you can carry the lamp in a simple and convenient way. The mirrored, magnetically attached bottom allows for its easy removal, which is especially useful for pedicures and for cleaning and disinfecting the lamp. The beautiful, white color and modern design will be the perfect complement to your office!

Lamp features:

   ◉ 30 evenly distributed diodes eliminate the risk of 'dead zones' of curing.
   ◉ Low Heat Mode allows for gradual heating of the lamp, especially useful when working with sensitive plates and building gels.
   ◉ Motion sensor that turns on the lamp automatically.
   ◉ Electronic display with timer.
   ◉ Removable, mirrored bottom makes it easier to perform a pedicure.
   ◉ Light and compact design.
   ◉ White light emission

€24.90 (VAT incl.) €24.90 (VAT excl.)
VAT included

Technical data:

   ◉ Maximum power: 48 W
   ◉ Number of diodes: 60
   ◉ Input voltage: 100-240V 50-60Hz 1A
   ◉ Output voltage: 24V 2A
   ◉ UV wavelength: : 365+405nm
   ◉ Cable length: approx. 100cm

Dimensions:

   ◉ Width: approx. 20 cm
   ◉ Height: approx. 9 cm
   ◉ Depth: approx. 16 cm

ATTENTION!

The bottom of the lamp is protected by a blue protective film, which must be removed before use.

Please disconnect the device from the power source after finishing work.

Lack of cut-off may cause the device to overheat

1 Item
5903775423270
chat Comments (0)